4 features 05 and 06 - left and right margins – AMT Datasouth 41AY89AR777 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.4.4
Features 05 AND 06 - LEFT AND RIGHT MARGINS
The left margin is the first printable column and the right margin is the last
printable column. These may be set in any of the following colxnnns:
1-132 at 10 cpi
1-163 at 12 cpi
1-203 at 15 cpi
1-217 at 16 cpi
However, the left margin must always be set to a value less than the right margin.
The feature number for the left margin is 05 and the right margin is 06.
Example with left margin at column 10 and right margin at column 80:
1.
Enter setup mode as described in Paragraph 2.4 and advance the display to
“05” (the feature margin for left margin).
2.
Press the Feature Value key and then advance the display to “ 10” (the desired
value for the left margin).
3.
Press the Set key to enter the value in the non-volatile memory.
4.
Press the Feature Number key to return to feature mode.
5.
Advance the display to “06” (the feature number for the right margin).
6.
Press the Feature Value key and advance the display to “80” (the desired valu
for the right margin).
7.
Press the Set key to enter the value in the non-volatile memory.
8.
Press the Exit Setup key to exit setup mode.
NOTE
The left margin must have a lower value than the right margin.
If an illegal command is entered, the “BELL” will
sound indicating that the command has not been accepted.
CAUTION
Margins must be set properly to avoid printing off the form,
which can damage the printhead.
2-7