Connections, Basic connections, 1 connect the speakers with the unit – Aiwa SX-NV20 User Manual
Page 8: Note, N connections, 2 connect the supplied antennas, See iiiustration
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

2-n
CONNECTIONS
BASIC CONNECTIONS
Connect the equipment and accessories following steps 1 to 3.
After connecting the foliowing items, as shown in iilustration Q,
the unit is ready for operation.
• Refer also to page 34 on connecting optionai equipment, for
example, a television or turntable.
1 Connect the speakers with the unit.
Connect the right speaker to the R terminai, and the ieft to the
L terminai.
Open the lever of the speaker terminals and insert the conductor
of the speaker cords with the stripe to ® and that of the other
cords to ©.
Then, shut the lever to lock.
If connecting speakers other than the supplied ones
Use speakers with an impedance of 6 ohms.
NOTE
• This speaker system is magneticaliy shieided. However, if
the speaker should affect the color on your TV screen, turn off
the TV and turn it on again 15-30 minutes later. If the TV
screen still has poor color, place the speaker system away
from the TV.
• Do not leave magnets or objects generating magnetism near
the speaker system.
2 Connect the supplied antennas.
-*
See iiiustration
2 - Q .
Push the lever of each terminal, and insert the conductor. Then,
release the lever to lock.
FM:
Connect the conductor of the FM feeder antenna @to the
FM 75 £i terminals.
AM:
Connect the conductor of the AM loop antenna ©to the AM
LOOP terminals.
8
To be continued.