Aiwa SX-NV20 - Manual (Page 6)

PRECAUTIONS
Follow the advice below for safe and correct operation.
On AC voltage
Before use, check that the rated voltage of your system matches
your local voltage.
On placement
• Do not use the system in places which are extremely hot, cold,
dusty or humid.
• Place the system on a flat, even surface.
• Be careful not to obstruct the ventilation holes on the rear panel,
as increased internal temperature may affect the electric parts. In
particular, do not place the system in an airtight rack.
• If using the system near television or radio, noise may be heard
from the television, radio or this system. Keep this system away
from the affected television or radio.
On safety
• When connecting and disconnecting the AC cord, grip the plug
and not the cord itself. Pulling the cord may damage it and
thus be hazardous.
• When you are not going to use the system for a long period of
time, disconnect the AC cord. If the cord is plugged in, a small
amount of current keeps on flowing to the system even if the
power switch is not ON.
• If the AC cord is broken or damaged, or if the wires are
exposed, contact your dealer or an Aiwa service station and
have it replaced or repaired immediately.
On condensation
When the room is heated, you sometimes see water drops on your
windows; this is called condensation.
This can occur inside the CD player unit when;
• it is moved from a cold spot to a warm spot.
• it is used in a room where the heating system has just been
turned on.
• it is used in a place with a lot of moisture.
• it is used where it has direct contact with cool air, such as near
an air-conditioner.
When it has condensation inside, the unit may not function nor­
mally. Let it stand for 1 to 2 hours before turning the power on; or,
gradually heat the room and dry the unit before use.
Should any trouble occur, disconnect the AC cord and refer
servicing to qualified personnel only.
6