Aiwa SX-NV20 - Manual (Page 44)

10
TIMER SETTING
9 Adjust the volume and tone.
10 Press the POWER button to turn the unit power off.
Only © is displayed, and the unit enters the timer standby
mode. When the timer-on time is reached, the unit is turned on
and play begins in the selected source.
11 Get ready fortheTAPEfunctionorthe timer record­
ing.
To listen to the tape
Press the > button.
10 POWER
i STANDBY/ON ^
To record the source
Press the • button on deck 1.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the timer
recording period, the • button on deck 1 is released before the
timer is off.
When the tape length is longer than the timer recording period, the
• button is not released. If the • is not released for a long time,
the tape in the deck may be damaged. Press the ■ / button to
release the • button.
/ / /■ .J
I I I - I ‘
To cancel the timer standby mode temporarily
While pressing the SHIFT button, press the TIMER button so that
0 goes out in the display.
To restore the timer standby mode, press the TIMER button while
pressing the SHIFT button to display 0 .
If using the unit after setting the timer
After setting the timer, you can use the unit. After using the unit,
check whether the contents in steps 8 and 9 are set as you wish,
turn off the power and set step 11 if necessary.
To change the specified time and function
Repeat all the steps again.
To check the specified contents
While pressing the SHIFT button, press the TIMER button. The
timer-on time is displayed for 4 seconds.
NOTICE
• If the power is on, the timer will not work .
• The timer-on time cannot be set during recording.
• While setting the current time, the timer does not work.
• The connected equipment cannot be turned on and off by the
built-in timer of this unit.
• The timer-on period is not displayed after setting.
46