Aiwa SX-NV20 - Manual (Page 36)

RECORDING
BASIC RECORDING
1
1
3
3 p O
T
^ rr
n-1 \m- |-| 17-n
II
1
\/±
( tuner / band ^ j
t?
I RMK TOP wa S 3
/ '
--/ c r
'' /_ /_
RECORDING FROM A CD, RADIO OR
CONNECTED EQUIPMENT
Preparation
• Wind up the tape to the point recording starts.
• Note that recording is done on only one side of the tape.
• Use only normal (type I) tapes.
1
Insert the tape to be recorded on into deck
1
and
push the cassette holder to close it.
Press the ■ / ^ button to open the cassette holder.
Insert the tape with the side to be recorded on facing you and the
exposed side down.
2 Get ready for the source to be recorded.
To record from a CD
Press the CD button and load a disc.
To record from a radio broadcast
Press the TUNER/BAND button and tune in to a station.
To record from the connected source
Press the VIDEO/AUX button and play it.
3 Press the • button to start recording.
The > button is depressed simultaneously.
When recording from a CD, playing and recording start
simultaneously from the first track.
To stop recording
Press the ■ / A button.
To pause recording
Press the II button.
To resume recording, press it again.
To record selected tracks of the CD
Before pressing the • button, program the tracks (see page 26).
To record part of the CD
When the • button is pressed, recording always starts from the first
track. To start in the middle of a track, play the CD first and press
the
II button for CD at the point you wish to start recording from.
Then, press the • button. The pause mode for CD button is
released automatically and recording starts.
To erase a recording
A previous recording is erased when a new recording is madeon
that part of that tape.
1 Insert the tape you want to erase into deck 1.
2 Press the TAPE button.
3 Wind up the tape to the point where the erasure is to be started.
4 Press the • button on deck 1 to start erasure.
36