Aiwa SX-NV20 - Manual (Page 26)

CD PLAYING
PROGRAMMED PLAY
Q
0
1
j
1
ooo
^ ;
(Operating with only the remote control)
The player has a memory function that allows play of up to 30 tracks
over three discs in any order.
1 While pressing the SHIFT button, press the PRGM
button in the stop mode.
2 Press one of the DISC DIRECT PLAY buttons to
select a disc.
The selected disc is indicated in red in the display.
Go to the next step when the tray stops rotating.
3 Press the numeric buttons and the +10 button to
program tracks.
To select the 6th track, press the 6 button. -»See illustra­
tion @.
To select the 16th track, press the -r 10 and 6 buttons.
See illustration (g).
To select the 20th track, press the +10 button twice and
then the 0 button. -> See illustration ©.
DISPLAY
@ Program number
(D Disc number
@ Selected track number
The display changes in a few seconds.
© Total playing time of the selected tracks
® Total number of selected tracks
4 Repeat steps 2 to 3.
5 Press the P- button to start play.
To check the programmed contents
Each time the DOWN or ►► UP button is pressed in the stop
mode, a disc number, a track number, and a program number will
be displayed.
To clear the programmed contents
Press the ■ CLEAR button in the stop mode or press the ^ OPEN/
CLOSE button.
To add tracks to the program
In the stop mode, carry out steps 2 and 3. The track will be
programmed next to the last track.
To change the programmed tracks
Clear the program and carry out all the steps again.
NOTICE
' The DISC CHANGE button does not operate during programmed
play.
' During programmed play, the remaining time is not displayed
when the DISPLAY button is pressed.
' Random play cannot be done during programmed play.
' If programmed time is more than 99:59 minutes, total playing time
shows in the display.
26