Aiwa SX-NV20 - Manual (Page 12)

BEFORE OPERATION
POWER
* STANDBY/ON
' •:% -.5; .
Si
■ '“■ i; -3-
a'ir.
0
□
-
“'yj
ON THE MAIN UNIT
To turn on the unit See illustration
Press the POWER button. The disc compartment may open and
close for resetting the unit.
For 4 seconds afterturning on the unit, only the function buttons and
the VOLUME control can be operated.
After use
Press the POWER button to turn off the power. The display
indication is faded and only the clock is displayed.
Headphone use
Connect headphones with a o6.3 mm/ 'U in. plug to the PHONES
jack. When the headphones are connected, sound cannot be heard
from the speakers.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs to
be reset (see page 14).
• If power is interuppted for more than approximately 24 hours, the
preset stations and timer settings need to be reset.
Flash window -r See illustration □.
The flash window lights up while the power is turned on and flashes
when the disc compartment is opened or closed, and while the disc
trays are accessed.
To turn it off, press the CD button while pressing the ■ CLEAR
button.
To turn it back on, repeat the above.
• Do not perform this operation during recording.
ON THE REMOTE CONTROL
Remote control setting
Detach the battery cover on the rear of the remote control and insert
two R6 (size AA) batteries. -► See illustration Q.
Battery replacement
The maximum operation distance of the remote control should be
approximately 5 meters (16 feet). When this distance decreases,
replace the batteries with new ones.
NOTE
• Do not mix different types of batteries, or old batteries with new
ones.
• When you are not going to use the unit for a long period of time,
remove the batteries to prevent possible electrolyse leakage.
Hints for correct operation
The remote control may not operate correctly when:
• the line of sight between the remote control and the remote sensor
of the unit is exposed to intense light, such as direct sunlight.
• other remote controls are used nearby (television, etc.).
To use the 0 buttons -* See illustration Q].
Each of the buttons has two different functions. One of these
functions is indicated on the button top, and the other on the plate
above the button.
To use the function indicated on the button top, just press the
button.
To use the function indicated on the plate above the button,
press the button while pressing the SHIFT button.
To use the FUNCTION button -»See illustration Q .
The FUNCTION button substitutes for the function buttons (TAPE,
TUNEFi/BAND, VIDEO/AUX, CD) on the main unit. Each time the
FUNCTION button is pressed, the functions are selected cyclically.
12