Aiwa SX-NV20 - Manual (Page 32)

CLEAR
II SET
i=n»c;3Ci C2
^ Ì5 O
rTrn-r^::Dr-r-r-m
2
3
RADIO RECEPTION
TUNING
m
TO A PRESET STATION
(See illustration □.)
1 Press the TUNER/BAND button to select a band.
2 Check whether the preset tuning mode is selected.
If a preset number © is displayed, the preset tuning mode is
already selected. Skip this step.
If a preset number is not displayed, press the > button.
3 Press the « DOWN or ►► UP button to select a
preset number.
Each time it is pressed, the preset number is changed.
NOTICE
Frequencies have already been set for each preset number in the
factory.
Each of them can be replaced by your desired station, or it can be
skipped by carrying out the following steps.
To skip needless preset numbers (preset skip function)
You can skip a preset number that need not be received.
1 Press the l> PRESET/TUNING button to extinguish the preset
number, if it is displayed in the display window.
2 Press the II SET button so that the preset number flashes.
3 Press the DOWN or ►► UP button to display the preset
number you want to skip.
4 Press the ■ CLEAR button.
The mark and the preset number flash in the display.
-»See illustration QJ.
5 Press the II SET button.
The mark and the preset number in the display flash and
go out. The setting is completed.
To restore the skipped preset number
Follow steps 1 to 5 of “To skip needless preset numbers”.
In step 4, the mark is deleted.
To change the AM tuning interval
The AM tuning interval is factory-set to 10 kHz.
If you use this unit where the frequency allocation system is 9 kHz,
press the POWER button to turn off the power. Then, while
pressing the TUNER button, press the POWER button. To reset
the interval, repeat this procedure.
NOTICE
After changing the AM tuning interval, the preset stations of any
band you have preset (see page 30) are cleared. The preset
stations have to be set again.
32