Aiwa SX-NV20 - Manual (Page 14)

1,3,5
2,4
1
N 7j'n n
UPW WDOWN p.
o
\ ' /
ri'jTi i~i
..
2,'-'^' !-<
■7TT"
11 II I i I _
I I T I I ‘ '
/ I \
i " 1 ( -~i
iM
DOWN ^ UP W
//i-/S -
/1 \
li
SHIFT
CLOCK
CLOCK SEniNG
When the AC cord is connected, the clock display flashes. Carry
out the following steps while the power is off.
1 Press the
li
SET button to enter the clock setting
mode.
The display indication becomes bright and the “hour” flashes.
2 Press the « DOWN or »■ U P button to designate
the hour.
3 Press the II SET button to set the hour.
The “hour” stops flashing and the “minute” starts flashing.
4 Press the ◄◄ DOWN or ►► UP button to designate
the minute.
5 Press the II SET button to set the minute and
complete setting.
The minute stops flashing in the display and the clock starts
from 00 second. The display indication becomes dim.
To get a more accurate time, press the
II SET button at the
desired point, as indicated by another clock or time signal.
Each colon flash in the display indicates a second.
To correct the current time See illustration Q .
While pressing the SHIFT button, press the CLOCK button on the
remote control. The clock is displayed for 4 seconds.
Within this period, start correcting by following steps 1 to 5.
To switch display to clock while power is on
While pressing the SHIFT button, press the CLOCK button on the
remote control. The clock is displayed for 4 seconds.
During recording, the clock cannot be displayed.
To switch to the 24-hour standard
The time display is factory-set to the 12-hour standard. To switch
to the 24-hour standard, press the CLOCK button on the remote
control while pressing the SHIFT button and then press the ■
button within 4 seconds. Repeat the same procedure to restore the
12-hour standard.
If the clock display flashes while the power is off
This is caused by power interruption. Set the current time again.
14