Toa N-8000 Series Ver.1.41 - Manual (Page 77)

2-25
Chapter 2: FUNCTIONS AND OPERATION
3.1.3. All-call paging
Paging calls can be made simultaneously to all of the pre-programmed zones.
Use the supplied N-8000 Software program to set the paging zones. (Refer to
p.5-61 .)
Step 1. Press the Paging key, followed by he paging zone number 0 (for all-call paging).
A paging tone is transmitted to all zones.
Note
Enter a zone number with the same digit length (1 – 3 digits) set with the N-8000 Software program.
Step 2. Page with the handset either lifted or in place.
Note
If the system's paging response mode has been set to designate the zone number (Refer to
p. 2-28 ),
notify the paged party to respond to [0] in the paging message.
Step 3. Either press the Clear key or replace the handset to terminate the page.
The paging is completed.
1
3
2
Zone 1
Amplifier
Speaker
No. 100
Zone 160
Amplifier
Speaker
or
C
or
0 0 0
(Zone number with 3-digit length)
3.1.4. Paging priority
The all-call paging has the highest priority, while the zone paging and selectable paging are the same in
priority level.
• Initiating the all-call paging during the zone or selectable paging terminates the zone or selectable paging,
allowing the all-call paging to go through.
• Initiating another paging of the same priority during a paging causes the later paging to be held busy when
the paged station or in-use PA paging output overlap.