Toa N-8000 Series Ver.1.41 - Manual (Page 39)

1-26
Chapter 1: GENERAL DESCRIPTION
2
1
11
3
4
5
9
10
6
7
8
12
6.10. N-8031MS Flush-Mount Master Station
[Front] [Rear]
1. Status indicator (Red)
Flashes when a call is received, continuously
lights during a conversation, and is off while in
standby mode. The indicator also continuously
lights while receiving a paging announcement.
2. Paging key [CALL]
Makes a paging. (Refer to p. 2-23 .)
3. Hold key [HOLD]
Places the conversation on hold. (Refer to p. 2-11 .)
4. Push-to-talk key [PTT]
Pressing this key while calling a party by means of
a continuous call tone permits a voice call to be
made. (Refer to
p. 2-7 .) Also, pressing this key
during a hands-free conversation establishes a
one-way conversation from the party who pressed
the key.
(Refer to
p. 2-6 .)
5. Speaker
Outputs call tones and used for hands-free
conversations.
6. Paging response key. [RESP.]
Responds to a paging. (Refer to p. 2-27 .)
7. Function key [FUNCTION]
Use this key to perform function settings such as
assigning call transfer recipients or programming
one-touch dialing.
8. Redial key [REDIAL]
Permits the last called number to be dialed.
(Refer to
p. 2-6 .)
9. Transfer key [TRANSFER]
Used to transfer the current conversation to
another station. (Refer to
p. 2-12 .)
10. Dial keys
Use these keys to make a call or set a function.
11. Clear key [C]
Terminates the conversation.
12. Microphone
Used for hands-free conversation.
13. Line connection terminals [1, 2]
Connect to the exchange. (Pin header)
Note
The removable terminal plug (2P) is factory-
attached. (Refer to
p. 3-22 .)
7
8
9
C
COM
1 2
13
14
15