Toa N-8000 Series Ver.1.41 - Manual (Page 54)

2-2
Chapter 2: FUNCTIONS AND OPERATION
1. BASIC USAGE
Operation is the same for both the stations connected to the exchange and the IP stations connected to a
LAN.
1.1. Calling from a Master Station
Step 1. Dial the number of the station to be called.
• Dialing from a master station is possible with its
handset either lifted or in place.
The calling station's internal speaker sounds an
audible call tone (heard in the handset speaker if
the handset is lifted).
When a busy tone is heard, wait till the line becomes
free, and you are automatically connected to the
called party.
Step 2. Conversation can begin when the calling tone stops
and the called party responds.
• When the called station is set to Automatic
connection mode*, the calling party is
automatically connected after a brief call tone and
conversation can begin.
• When the called station is set to Continuous call
tone mode*, a continuous call tone sounds until
the called station responds, after which
conversation can begin.
Step 3. When conversation is finished, press the Clear key
or replace the handset.
* Use the supplied N-8000 Software program to perform Automatic connection mode/Continuous call tone
mode setting. (Refer to p.5-52, 5-56 .)
Note
If the system has been set for call time-out or conversation time-out, the call or conversation automatically
stops after the specified time limit. The specific length of this time-out (in 10-second units between 10 and 999
seconds) is preprogrammed into individual exchanges or IP stations using the supplied N-8000 software .
(Refer to
p. 5-30 , 5-49. )
or
1 5 1 5
Call tone
Call tone
or
Master station Master station
or
or
C