Toa N-8000 Series Ver.1.41 User Manual

Page 187

5-43

Chapter 5: SYSTEM SETTINGS BY SOFTWARE

Multi Interface: Contact Input

Aux input paging:

Select this item when activating playback components or other devices connected
to the Multi interface unit's audio input terminal from the control input.

Paging busy 1:

Select this item when sending externally-connected paging equipment's busy
status data to the Audio output 1.

Paging busy 2:

Select this item when sending externally-connected paging equipment's busy
status data to the Audio output 2.

Remote dial control: When the Multi interface unit's contact input terminal is closed, a station is made

to automatically perform dial operation. A set of up to 20 dial codes (including dial
numbers and key operations) can be assigned to each contact input terminal.

Unused:

The contact input is not used.

(3) Interlock contact

Set the contact numbers (Multi interface unit's unit number and contact output terminal number) to be
output when "Input interlock level" or "Input interlock edge" is selected in the operation mode setting.

(4) Aux input paging

Set the paging zone number and the audio input terminal number of paging source when "Aux input
paging" is selected in the Operation mode setting.

(5) Remote dial control

Set the equipment number of exchange and line number to which the remote-controlled station is
connected. Referring to the table below, enter the dial codes that correspond to the dial operation the
station is made to perform.
• The table below shows assignable keys or operations vs. dial codes to be registered.
• A set of up to 20 dial codes can be registered.

Dial code

Assignable key or operation

Press PTT key (PTT key is on.)

Release PTT key (PTT key is off.)

Dial code

Assignable key or operation

Paging call

Paging response

HOLD

TRANSFER

FUNCTION

REDIAL

SELECT

Left arrow key ( )

Right arrow key ( )

Up arrow key ( )

Down arrow key ( )