Toa N-8000 Series Ver.1.41 - Manual (Page 197)

5-53
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 2
(5) BGM
Set whether the IP station receives BGM broadcasts. If receiving, place a checkmark and select the BGM
channel number (1 – 8; Channel No.).
(6) Door station mode (IP door station only)
Set whether to operate the IP door station in door station mode*.
* The call tone sounds only once at the IP door station when the IP door station calls the pre-programmed
master station. The call timeout and conversation timeout are set to 30 seconds each.
(7) Access to priority call operation (IP master station only)
Enables the IP station to initiate priority calls.
(8) Refusal of priority call operation
Enables the IP station to refuse priority calls from other stations.
(9) Access to paging call operation (IP master station only)
Enables or disables paging calls from the IP station.
(10) External equipment control (IP master station only)
Set whether the one-shot make contact output or make/break contact output is operated at the IP station.
(11) Door Remote
Set the Multi interface unit's unit number and contact output terminal number to be used for door remote
control.
(12) Calling station indication/CCTV control
Control output No.: Set the Multi interface unit's unit number and contact output terminal number,
which provide a make contact when the station is called.
Called party's station No.: Provides a make contact when the station to be set here is called. Up to 8
stations can be set.
(Example)
The operation example illustrated below is based on the following settings:
Station No. (for IP station): 148
Control Output
MI Equipment No.: 5
Contact output No.: 6
Called station's No.: 149
Call
No. 148
No.149
1 4 9
N-8000MI (Equipment No. 5)
Contact Output No. 6
Make contact
The Multi interface unit's (equipment No. 5) Contact No. 6 closes when the station No. 148 calls the
station No. 149.