Toa SX-2000 Series Manual User Manual
Page 94
9-3
Chapter 9: RM-200SA REMOTE MICROPHONE
RM-210 REMOTE MICROPHONE EXTENSION
10. Talk Key
Press this key to broadcast a voice announcement.
If the Talk key is set to "PTT" ("press-to-talk")
mode, then it must be pressed continuously for
the duration of the broadcast. If the Talk key is
set to "Lock" mode, then it must be pressed once
to turn the microphone on at the beginning of a
broadcast, then pressed again to turn the
microphone off once the broadcast is finished.
The microphone can also be set to sound a
chime at the beginning and/or end of each
broadcast.
The Talk key mode ("PTT" or "Lock") and the
chime function are set using the SX-2000 Setting
Software. The RM-200SA of which "Type" is set
to "General/Emergency" on the SX-2000 Setting
software is fixed to "PTT" mode for the Talk key
with no chime activation. (See the separate
Setting Software Instructions, "System Settings.")
11. Function Keys (L1 – L3)
Positioned in top-down order (L1, L2, L3).
These keys operate in the same manner as the
Function keys (R1 – R10) (No. 9).
12. Broadcast Status Indicator (Yellow/Green)
Lights, flashes, or goes off depending on the
current operation state of the Talk key.
13. Microphone Indicator (Green)
Lights or goes off depending on the current
operation state of the Talk key.
Flashes while the chime is being activated.
[Side]
14
15
14. DIP Switch
Used to assign device numbers, set the CPU OFF
function (general urgency all-call) to enabled or
disabled, etc.
(For making general urgency all-calls, see
and for setting DIP switch, see the separate
Installation Manual, "Installation.")
15. RM-210 Extension Connector
This port is used to connect RM-210 extension
units.