Toa SX-2000 Series Manual - Manual (Page 62)

5-4
Chapter 5: SX-2100AO AUDIO OUTPUT UNIT
[Fluorescent Display]
COM
FAULT
KEYLOCK
EMERGENCY
OL
0
–10
–20
–30
–40
OL
0
–10
–20
–30
–40
FADER
LEVEL LEVEL
1 2 3 4 5 6 7 8
1 2
21
22 23 24 25 26 29 30 31 32 33 34 35 36 37
3 3
27 28
21. Text Display Area
Displays the menu screen information when the
corresponding function key is pressed.
22. COM Indicator [COM]
Flashes to indicate a communications error.
23. Fault Indicator [FAULT]
Flashes when a system failure, incorrect system
configuration*
1 or communications error is
detected. This indicator continues to flash until
failure conditions return to normal.
* 1 When the system or module configuration
differs from the contents set by the SX-2000
Setting Software.
24. Output Level Meter Fader Indicator [FADER]
Lights when the output level meter indicates the
sound volume set using the SX-2000 Setting
Software or output volume control.
25. Output Level Meter Level Indicator [LEVEL]
Lights when the output level meter indicates the
level being output from the SX-2100AO.
26. Output Level Meter Scale
27. Output Indicator
The output channel to be monitored lights red.
28. Output ON/OFF Indicator
Indicates the unit's operating status when the
corresponding channel key is pressed.
The indicator state differs depending on the
function assigned to each channel key as
follows.
* The indicator state is "Unlit" when the output volume is muted.
29. Output Level Meter
Indicates the actual level or a set volume value
on each output channel.
30. Emergency Indicator [EMERGENCY]
Lights when the SX-2000 system is in an
emergency condition.
31. Key Lock Indicator [KEY LOCK]
Lights when the output volume controls and
channel keys are all locked. (See
p. 5-6 "Key
Lock Settings and Cancellation." )
32. Local Audio Input Level Meter
Indicates each level of signals applied to the
Local audio inputs 1 and 2 while the Local audio
control inputs 1 and 2 are activated, respectively.
Function assigned to the channel key When ON When OFF
Output ON/OFF Lights* Unlit
General-purpose pattern broadcast Flashes Lights
Notes
• A timer-activated light shutoff function can be set for the fluorescent display using the SX-2000 Setting
Software. (See the separate Setting Software Instructions, "Basic Settings.")
When the light shutoff function has been set, if the SX-2100AO is not operated for 5 minutes or more, the
fluorescent display's light goes off and the standby indicator (11) begins to flash. Pressing any keys other
than the function keys on the front panel resets the screen display.
• Normally, the fluorescent display's light goes off at the time of the power failure.
• While the SX-2000 system is in an emergency condition, the fluorescent display's light does not go off even
if the power fails.