Toa SX-2000 Series Manual - Manual (Page 121)

4. MAKING LOCAL BROADCASTS (SX-2100AO only)
Described below are system operation procedures when making local broadcasts via the SX-2100AO.
[Setting example]
Notes
• For the setting procedures, refer to the separate Setting Software Instructions, "AO Event Settings."
• For the pin arrangement diagram, refer to the separate Installation Manual, "Input Equipment Connections."
Step 1. Close the Local input 2's control input.
Local input 2 is output to the set zones (Zones 1 – 7).
Step 2. Close the Local input 1's control input.
Local input 1 is output to the set zones (Zones 1 and 2).
Tip
Local input 1 has a higher priority than Local input 2.
Step 3. Make general broadcasts to the Zone 2.
Tip
The Local input has a lower priority than the BGM or
general-purpose sound sources.
Step 4. Make emergency broadcasts to the Zone 1.
Activating the emergency broadcasts to a part of zones
where local broadcasts are currently in progress causes
all local broadcasts to terminate.
10-16
Chapter 10: OPERATION
Local input 1 Zone 1, Zone 2
Local input 2 Zone 1, Zone 2, Zone 3, Zone 4, Zone 5, Zone 6, Zone 7
Zone 1 Local input 2
Zone 2 Local input 2
Zone 3 Local input 2
Zone 4 Local input 2
Zone 5 Local input 2
Zone 6 Local input 2
Zone 7 Local input 2
Zone 1 Local input 1
Zone 2 Local input 1
Zone 3 Local input 2
Zone 4 Local input 2
Zone 5 Local input 2
Zone 6 Local input 2
Zone 7 Local input 2
Zone 1 Local input 1
Zone 2 General-purpose broadcast
Zone 3 Local input 2
Zone 4 Local input 2
Zone 5 Local input 2
Zone 6 Local input 2
Zone 7 Local input 2
Zone 1 Alert
Zone 2 General-purpose broadcast
Zone 3
Zone 4
Zone 5
Zone 6
Zone 7