Toa SX-2000 Series Manual - Manual (Page 122)

10-17
Chapter 10: OPERATION
5. ADJUSTING INPUT/OUTPUT VOLUME
It is possible to adjust the volume for each input channel via the front panel of the SX-2000AI or SX-2100AI.
It is also possible to adjust the volume for each output channel via the front panel of the SX-2000AO or SX-
2100AO.
The adjustment method is the same for both.
Channel key
Fluorescent display
* These volume knobs and indicators are the output volume knobs and output ON/OFF indicators
in the case of SX-2000AO and SX-2100AO.
Input volume knob*
The figure shows the SX-2100AI.
3 3
Input ON/OFF indicator*
[When the channel key is set for the input (output) ON/OFF function (default setting)]
Set the channel key for the desired input (output) channel to ON, then use the volume knob above it to adjust
the volume.
When the channel key is set to ON, the input (output) ON/OFF indicator on the fluorescent display lights.
However, if the input (output) volume knob has been set to the minimum volume position by rotating it fully
counterclockwise, the channel remains OFF and the input (output) ON/OFF indicator also remains unlit.
The setting value for the input (output) volume knob can be confirmed using menu screen (AI8, ai8, AO8, ao8).
(See
p. 2-12 , 3-12 , 4-12 , 5-12 .)
[When the channel key is set for other function except input (output) ON/OFF function]
The channel corresponding to that channel key is always ON.
Therefore, the volume on the channel can be adjusted only by turning the corresponding volume knob.
The setting value for the input (output) volume knob can be confirmed using menu screen (AI8, ai8, AO8, ao8).
(See
p. 2-12 , 3-12 , 4-12 , 5-12 .)