Toa SX-2000 Series Manual - Manual (Page 80)

8-2
Chapter 8: RM-200SF FIREMAN'S MICROPHONE
1. NOMENCLATURE AND FUNCTIONS
[Top]
FIREMAN'S MICROPHONE
RM-200SF
MIC SP CPU
OFF ON
1
2
3
4
5
6
7 8
9
10
11
12
13
14
15
16
17
18
[Hand-held microphone]
1. Power Indicator (Green)
Lights when the power is turned on.
2. Emergency Key
Assign emergency broadcast pattern start function
to this key using the SX-2000 Setting Software.
Lights when the SX-2000 system is in an
emergency condition.
3. Monitor Speaker
Not used.
4. Monitor Speaker Volume Control [SP]
Not used.
5. Microphone Volume Control [MIC]
Adjusts the input sensitivity of the Hand-held
Microphone.
6. Microphone Hanger
Used to hold the unit's Hand-held Microphone.
7. CPU Switch [CPU ON/OFF]
Normally set to ON. (Factory-preset: ON)
Setting this switch to OFF in combination with the
DIP switch setting on the bottom surface allows
the general urgency all-call to be made using a
hand-held microphone by way of analog
transmission not via the CPU control.
8. Indication Label Insert Slot
The label can be printed using the SX-2000
Setting Software. (See the separate Setting
Software Instructions, "Printing Labels for
Remote Microphones.")
9. Failure Indicator (Yellow/Red)
Flashes yellow if some problem within the
system is detected.
This indicator will light yellow if the signal to the
SX-2000AI or SX-2100AI to which the RM-
200SF is connected is interrupted for 5 seconds
or more.
Lights red when the unit is placed in reset state
by pressing the Reset Switch (11).
10. CPU Indicator (Red)
Lights red when any one of the CPU switches on
the RM-200SFs connected within the system is
set to OFF or when the general urgency all-call is
being made by any one of the RM-200SAs
connected within the system.
11. Reset Switch
Used to reactivate the RM-200SF unit.
Holding down both this switch and the R3 key of
the Function keys (14) for 2 seconds or more
causes the Failure Indicator (9) to light red,
placing the RM-200SF in reset state.