Toa SX-2000 Series Manual - Manual (Page 112)

Broadcast status indicator
Pattern selection indicator
Function key
R6
(general broadcast
pattern 1)
Flashes yellow
Green
10-7
Chapter 10: OPERATION
1.2.3. Example of BGM broadcasting
Following is the operation example in the case where BGM broadcast is made by the BGM pattern 1 in the
morning and changed to the BGM pattern 2 in the afternoon, and then ended.
Step 1. Press the Function key L1 (BGM pattern 1).
BGM pattern 1 is selected and activated.
After the pattern selection indicator next to
Function key L1 lights green then goes off, the
broadcast status indicator lights yellow.
Note
To cancel the selection, press Function key L3
(BGM end). The broadcast status indicator will go
off.
Step 2. Press the Function key L2 (BGM pattern 2).
BGM pattern 2 is selected, ending BGM pattern 1,
and BGM pattern 2 is activated.
After the pattern selection indicator next to
Function key L2 lights green then goes off, the
broadcast status indicator lights yellow.
The broadcast status indicator next to Function
key L1 goes off.
Step 3. Press the Function key L3 (BGM end).
BGM ends. All indicators go off.
1.2.4. Example of general broadcasting
Step 1. Press the Function key R6 (general broadcast
pattern 1).
General broadcast pattern 1 is selected and
activated.
After the selection indicator next to Function key
R6 lights green, the broadcast status indicator
flashes yellow.
Step 2. Press the Function key R6 (general broadcast
pattern 1) again.
General broadcast pattern 1 being activated
stops.
The pattern selection indicator and the broadcast
status indicator next to Function key R6 go off.
Broadcast status indicator
Pattern selection indicator
Function key
L1
(BGM pattern 1)
Yellow
Function key
L1
(BGM pattern 1)
L2
(BGM pattern 2)
Yellow
Function key
L1
(BGM pattern 1)
L2
(BGM pattern 2)
L3
(BGM end)
Function key
R6
(general broadcast
pattern 1)