Toa SX-2000 Series Manual - Manual (Page 110)

Function key
Talk key
R1
(Zones 1, 2 and 3)
R2
(Zone 1)
R3
(Zone 2)
R4
(Zone 3)
Green Yellow
Green Yellow
Talk key
Yellow
Flashes
green
Broadcast status indicator
Microphone indicator
R1
(Zones 1, 2 and 3)
Green Yellow
10-5
Chapter 10: OPERATION
1.2.1. Example of broadcasting to the selected (pattern-designated) zone
Step 1. Press Function key R1 (zones 1, 2 and 3).
All of the designated zones are selected, and the
zone selection indicator next to Function key R1
lights green.
Note
To cancel the selection, press Function key R1
again, or press Function key R5 (zone clear).
The zone selection indicator will go off.
Step 2. Press the Talk key.
A chime will be broadcast. This chime will be
audible through the monitor speaker built in the
RM-200SA.
The Microphone indicator flashes
green while the chime is being
activated. (RM-200SA only)
Note
Pressing the Talk key again while
the chime is being activated
causes the chime to stop, ending
the broadcast in progress.
Step 3. When the microphone indicator next to the Talk
key lights green, make the microphone
announcement.
The zones assigned to Function keys R2 – R4 are
included within the zone selection pattern
assigned to Function key R1. Therefore, the
broadcast status indicators next to Function keys
R2 – R4 will light yellow in the same way.
Step 4. Press the Talk key.
The broadcast ends.
Step 5. Press Function key R5 (zone clear).
The zone selection is cancelled.
Note
If it is desired that the zone selection be left unchanged, there is no need to clear the selected zones.
Broadcast status indicator
Zone selection indicator
Function key
R1
(Zones 1, 2 and 3)
Green