beautypg.com

Section iii. learn the stitches, Starting to sew, Finishing sewing – Kenmore 385.166551 User Manual

Page 54: Sewing continuousiy, How to use guide iines, Sewing contiunously, How to use guide lines

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SECTION III. LEARN THE STITCHES

Starting to sew

Insert the fabric under the front of the foot.
(It is not necessary to raise the foot.)

Turn the handwheel gently toward you a couple of turns
and check the thread chain. Then start sewing slowly.
The fabric will be automatically fed. Guide the fabric in the
direction desired.

For heavyweight fabric, raise the presser foot and insert

the fabric in front of the knife. Then lower the foot and start
to sew while guiding the fabric.

Finishing sewing

When stitching is completed, continue to run the machine
slowly to produce a thread chain for about 5" (12 cm) while

pulling the thread chain lightly to the back.

Cut the threads with the thread cutter as illustrated,
leaving about 2" (5 cm) thread chain from the end of fabric.

® Thread cutter

Sewing continuousiy

Insert next fabric under the front of the foot, then start

sewing. It is not necessary to raise the presser foot for
ordinary fabric.

• For heavy weight fabric, raise the presser foot and insert

the fabric in front of the knife.
Then lower the foot and start to sew while guiding the

fabric.

How to use guide iines

On the top of the looper cover there are guide line notches

representing the distance of the fabric edge from the left and
right needles. There are 2 marks on each notch. Please use

as sewing guides.
(T) Mark i is the distance from the left needle.

(D

Mark I is the distance from the right needle

• The notches are 1/4" (6 mm) part.
• The center notch is labeled 5/8. which means that the

fabric edge is 5/8” (16mm) from the right or left needle.

46