Kenmore 385.166551 - Manual (Page 28)

Adjustment of cutting width
When cutting width is too narrow or too wide for seam
width, adjust as follows.
Q] Turn off the power switch and unplug the machine.
[H Open the looper and side covers.
U] Turn the cutting width adjusting dial to get desired
position of lower knife.
(A) When cutting width is too narrow:
Turn cutting width adjusting dial clockwise.
Lower knife will move to right.
(B) When cutting width is too wide:
Turn the cutting width adjusting dial
counterclockwise.
Lower knife will move to left.
[U Close the looper and side covers.
[5] Test stitch to check the cutting width.
• The cutting width of the model can be adjusted
approximately 1/8" to 3/16" {3.0 to 5.0 mm) from the
right needle position depending upon your sewing needs
or fabric being used.
[2] [3] H I
(A)
i
Standard
Estándar
Standard
(B)
i i
20