beautypg.com

Changing the needle, Note, To attach the needle on the left – Kenmore 385.166551 User Manual

Page 24: Adjustment of foot pressure

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Changing the needle

(T) Needle clamp screw on the left
(D Needle damp screw on the right

Q] Turn off the power switch and unplug the machine.
[U Turn the handwheel toward you until the needles are in

the full up position.

[U Then ioosen the needle clamp screw for the needle

which you are going to remove.

NOTE

Your Serger uses standard Kenmore sewing needles

(HA-1 SP,
No special needles are required.
Do not use any needle which is bent or blunt.

Do not use any needle which is bent or blunt.

(T) Needle clamp screws (|) Edge of needle bar
(2) Flat side to the back (D Needle
CD Needle clamp

@ Correct needle setting

0 Needle stopper pin

• To attach the needle on the right;

Insert new needle into the needle damp with the flat side

to the back until the top of needle touches the stopper

pin, then tighten the needle clamp screw on the right.

• To attach the needle on the left;

Insert new needle into the needle clamp with the flat side

to the back until the top of needle touches the edge of

needle bar, then tighten the needle clamp screw on the
left.

When the needles are set correctly, the left needle is higher
than the right one.

Adjustment of foot pressure

(T) Standard setting position
(D Top of the machine

(D

Adjusting screw

(J) To decrease
(D To increase

it is not necessary to adjust the pressure for normal sewing.

When you sew heavy or lightweight fabrics, turn the
adjusting screw (D:
• clockwise for heavyweight fabric.
• counterclockwise for lightweight fabric.

• For normal sewing, set the adjusting screw (D so that it

sits 1/16" (2 mm) below the top of the machine .
See the illustration.

16