beautypg.com

Plug in the machine and switch on the power, Operating instructions, Foot control use – Kenmore 385.166551 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SECTION II. GETTING READY TO SEW

Plug in the machine and switch on the power

® Power supply plug
(2) Outlet

(

1

)

Plug connector

0 Power switch
0 Machine plug

NOTE

Before inserting the plug into your machine, be sure the

power switch

0

is OFF.

1] Insert the machine plug 0 into the three-prong plug

connector

0

,

as shown. It will only fit one way.

2

] Insert the power supply plug

0

into the wall outlet

0

.

] Push the power switch

sewing light.

) to turn on the power and

Safety feature;

Your machine will not operate unless the power switch is
turned on. If you are interrupted or stop sewing, turn off
the power switch to prevent injury to children.

Operating Instructions:

This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is

intended to fit in a polarized outlet only one way. If the plug

does not fit in the outlet, reverse the plug. If it still does not

fit, contact a qualified electrician to install the proper outlet.

Do not modify the plug in any way.
Foot Controller Model YC-482P is used with
Serger Model 385.16655XXX.

XXX - represents numbers 000 through 999.

Foot control use

The foot control regulates the speed at which you sew.
To increase speed, gently press down with the ball of your

foot.

To decrease speed, release your foot pressure slightly.

NOTE

The foot control is sensitive and will increase or decrease
your sewing speed immediately. Practice on a scrap of

fabric to regulate your sewing speed to your satisfaction.