Positioning the telescoping thread guide bar, Attaching the spool cap and net, Raising or lowering the presser foot – Kenmore 385.166551 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Positioning the telescoping thread guide bar
® Thread guide
(2) Telescoping thread guide bar
(3) Stoppers
0
Spool pin
Q] Pull the telescoping thread guide bar 0 up as far as it will
go.
[U Turn the thread guide bar 0 until it dicks into position.
Thread guides 0 should stop directly above the
spool pins
0
.
NOTE
Make sure the two stoppers
0
on the thread guide shaft,
as shown, are set in at the correct position.
Attaching the spool cap and net
0 Spool holder
0
Spool pin
0
Spool cap
0Slit
When you use a small thread spool, remove the spool
holder
0
from the spool pin
0
.
Then place the spool with
its slit
0
side up, and put spool cap (f) on top.
0
Spool pin
© N e t
If the thread slips down from the spool during threading
and / or sewing, put a net © on the spool as illustrated to
prevent jamming. The nets are supplied with the machine.
Raising or lowering the presser foot
0
Presser foot lifter
0
Presser foot
By raising or lowering the presser foot lifter
0
,
the presser
foot
0
goes up and down.
While in operation, keep the presser foot
0
lowered except
for threading the machine or test running without thread.
NOTE
Thread tension will be released when the presser foot
lifter is raised.
12