beautypg.com

Rethreading the serger, Rethreading the serger -32 – Kenmore 385.166551 User Manual

Page 38

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Rethreading the Serger

Threading the lower looper

Open the iooper cover.

Place the spool of thread on the right side spool pin.
• Lower looper threading points are marked in green.
• A convenient threading chart is placed on the machine

body which is located inside the iooper cover

® Thread guide
(2) Thread guide piate

(

1

)

Lower iooper thread tension dial

0

Thread guide plate

0 Lower thread guide
® Lower iooper thread guide 1
© Lower thread take-up lever
0 Lower iooper thread guide 2

0

Lower iooper thread guide 3

® Lower looper thread guide 4
0 Lower looper

NOTE
If you remove the needle plate, the threading points of

lower looper are easier to see. Make sure the thread is
not caught by the needle plate when replacing the plate
after threading.

When threading, the lower looper pre-tension setting slider

must be set at the STD. position as illustrated.

0 Lower looper pre-tension setting slider

E Draw the thread through the right side thread guide ©

from back to front.
© Thread guide

If the thread slips out from the thread guide groove while

serging, pass the thread through the thread guide hole as
shown.

I

Pass the thread through the holes on the right side of the

thread guide plate as illustrated.
@ Thread guide plate