beautypg.com

Threading the right needie, Threading the right needle – Kenmore 385.166551 User Manual

Page 48

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Threading the right needie

Place the spool of thread on the spool pin second from the
left.
Right needle threading points are marked in blue.

A convenient threading chart is placed on the machine body
which is located inside the iooper cover.

(T) Thread guide

(D

Thread guide plate

(D Right needle thread tension dial
d) Front cover thread guide 1
(D Front cover thread guide 2
(6) Take-up lever cover
(7) Front cover thread guide 3
(|) Guide plate

(D

Needie bar thread guide

(J3> Right needle

[T]

Draw the thread through the thread guide second from

the left from back to front.
(T) Thread guide

if the thread slips out from the thread guide groove while

serging, pass the thread through the thread guide hole
again as shown.

\

2

\ Pass the thread through the second set of holes on the

thread guide as illustrated.
(

2)

Thread guide plate

U] insert thread between the tension discs.

Hold the thread at both ends and tug gently to ensure

the thread is correctly inserted between the tension

discs, (if the presser foot lifter is raised, the thread easily
inserts between the tension discs.)

(3) Right needie thread tension dial

[4] Pass thread through the front cover thread guide 1, then

pass the thread under the front cover thread guide 2 and

the take-up lever cover from right to left.

[s] Guide the thread over the front cover thread guide 3.
[6] insert the thread into the right slot of the guide plate.
m Raise the needie to its highest point and pass the

thread through the needle bar thread guide from left to

right.

(8) Thread the right needie from front to back and pull the

thread about 4" (10 cm) from the eye of the needle to the

back under the foot.

NOTE

When you puli the needie thread under the presser foot,

be careful not to wind the thread around the lower Iooper.

0 Front cover thread guide 1
0 Front cover thread guide 2
0 Take-up lever cover

0

Front cover thread guide 3

Guide plate
Needle bar thread guide
Right needie

40