KEYENCE LS-3100/3100W Series - Manual (Page 88)

82
Check
item
Problem Details of inspection Corrective action
Reference
page
Computer
output Computer data is not
output. • Is the baud rate correctly
set?
• Is the cable connector
securely connected to the
port?
• Has the computer been
turned ON before the
controller?
• Is the correct program used?
• Set the controller and compu-
ter to the same baud rate.
Note, however, that some
computers may not recognize
correct measurements when
set to a high baud rate.
• Check that the cable connec-
tor is securely connected to
the port.
• Be sure to turn ON the com-
puter first, then controller.
• Send a message such as
"X0" from the computer to
access the controller.
CHAPTER 9 Troubleshooting Guide
p. 27
p. 49
08.10.1, 10:57 AM 82