KEYENCE LS-3100/3100W Series User Manual
Page 58
52
CHAPTER 4 Functions and Controls
Entry Examples
• To specify "1" for program No., "Y" for segment selector, "1" for scanning
head No., and SEG (3, 4) for measurement segment: "P1Y1S3,4 CR"
• To specify "2" for program No., "X" for segment selector, and "OFF" for
segment check: "P2XSR CR"
• To specify "3" for program No., "X" for segment selector, "1" for scanning
head No., and "DIA" for measurement segment: "P3D CR"
• To set the number of measurements for averaging to 1,024, while not
changing the other settings on the front panel: "AA CR"
Setting Output Conditions
Sets the output conditions (processing methods for measured values) for the
desired program. The format differs with the setting item, as described
below.
Format:
( [P$] [C$] ) [COMMAND] CR
Note that one or more of the commands in ( ) can be omitted.
When [P$] is omitted, the current program No. will be valid.
When [C$] is omitted, the current channel No. will be valid.
Channel No.
Function
Command
Description
Setting tolerance
IS
Sets tolerance differentiation
differentiation output
output to ON
IR
Sets tolerance differentiation
output to OFF
Setting tolerance
T3
Sets 3-level differentiation
differentiation level
T7
Sets 7-level differentiation (3 or 7)
Setting tolerance
TAn
Sets value ("n") for HIGH3
range for 7-level
TBn
Sets value ("n") for HIGH2
differentiation
TCn
Sets value ("n") for HIGH1
TDn
Sets value ("n") for LOW1
TEn
Sets value ("n") for LOW2
TFn
Sets value ("n") for LOW3
Setting values
ASm, n
Sets "m" for +6 V, and "n" for -6 V
("m" and "n") for
(m > n)
analog output
voltage setting
[P$] [C$] List
[COMMAND] List
(To be continued)
Commands for setting functions
Function
Command
Description
Specifying program No.
P1
Specifies program No. 1
P2
Specifies program No. 2
P3
Specifies program No. 3
P4
Specifies program No. 4
P5
Specifies program No. 5
P6
Specifies program No. 6
P7
Specifies program No. 7
P8
Specifies program No. 8
P9
Specifies program No. 9
PA
Specifies program No. 10
Specifies output channel
V
Specifies output channel CH1
W
Specifies output channel CH2
Program No.
08.10.1, 10:56 AM
52