KEYENCE LS-3100/3100W Series - Manual (Page 59)

53
CHAPTER 4 Functions and Controls
Function Command Description
Setting arithmetic C0 Sets method "X"
operation method C1 Sets method "Y"
C2 Sets method "X+Y"
C3 Sets method "X-Y"
C4 Sets method "(X+Y)/2"
C5 Sets method "(X-Y)/2"
C6 Sets method "-X"
C7 Sets method "-Y"
C8 Sets method "-(X+Y)"
C9 Sets method "-(X+Y)/2"
Setting MN Sets NORMAL mode
measurement mode MP Sets P-P mode
ME Sets PEAK mode
MB Sets BOTTOM mode
Setting tolerance Hn Sets value ("n") for HIGH
range for 3-level (upper tolerance limit)
differentiation Ln Sets value ("n") for LOW
(lower tolerance limit)
Setting OFFSET On Sets value ("n") for OFFSET value
value
Setting display Gn Sets the number of display digits
digit deletion to be deleted
Note:
• Entry of the bracketed commands ([ ]) can be omitted.
• When no command for specifying program No. is entered, the pro-
gram currently used on the front panel is specified.
• When no command for specifying output channel is entered, CH1 is
specified.
• When there is an error in the format, all the commands in that format are
disregarded.
• Only one command for setting functions can be entered for one format.
Entry examples
• To specify "3" for program No., CH2 for output channel, and 10.0000 mm
for OFFSET value: "P3WO10.0000 CR"
• To specify 1.2345 mm for LOW1 of tolerance range for 7-level differentia-
tion, while not changing the other settings on the front panel: "TD1.2345
CR"
Commands for setting functions
08.10.1, 10:56 AM 53