KEYENCE LS-3100/3100W Series - Manual (Page 20)

14
CHAPTER 3 Quick Setup Procedures
3.3 Using LS-3100D(W) Controller with 2 Scanning Heads
The LS-3100D(W) uses 2 scanning heads for this measurement.
■ Applications
• Measuring outer diameter of coated wire
in the X and Y axes
• Measuring outer diameter of extrusion
molded parts
■ Setting
1. Initialize settings
2.
In the above setup, measurements from scanning head 1 are displayed on
the main display, and measurements from scanning head 2 are displayed on
the sub-display.
For details on tolerance setting, refer to p.23-26, 39, 40, 43 in this manual.
This appendix does not cover all of the LS-3100(W) functions. In addition to
the applications covered in this appendix, the LS-3100(W) can be used for
several other types of measurements.
For more details on functions and measurements, read chapter 4. (A cross
reference between this appendix and chapter 4 is given below.)
Setting number of measurements for averaging .......... p.21
Tolerance settings ........................................................ p.23-26, 39, 40, 43
Measuring outer diameter
Gap measurement 1
Gap measurement 2
Measuring roundness
Measuring eccentricity
p.30-32, 40-41, 89-96
Measuring target displacement
within the measuring range
Measuring edge movement
Measuring outer diameter in the X and Y axes
FNC
SET
DISP
SET
SET
DISP
X
Y =
= D
D I
I A
A
X
Y =
= D
D I
I A
A
X
Y =
= D
E I
D
A
G E 1
X
Y =
= D
E I
D
A
G E 2
X
Y =
= D
2
I
: A
D
I A
D
N I
O
A
R M A L
C
N H
O 2
R
- -
A V E 1 0 2 4
- - - - - - - - - -
Measurement value in Y-axis Measurement value in X-axis
OK
Measuring Outer Diam-
eters in the X and Y Axes
08.10.1, 11:14 AM 14