KEYENCE LS-3100/3100W Series - Manual (Page 10)

4
1-6. Preparation for Operation
CHAPTER 1 Preparation for Measurement
• Do not mount the scanning head to the place where a certain level of
electrical noise is applied or transferred. Isolate the scanning head if
electrical noise may be occured. Otherwise, laser diode may deteriorate
or become damaged.
• Although the LS controller has been thoroughly inspected before ship-
ment, we kindly request that you check it upon purchase for any damage.
Contact the nearest KEYENCE distributor if your LS controller is damaged
in any way.
• Precision components are incorporated in the scanning head, therefore be
sure not to subject it to shocks.
• The scanning head has been precision set before shipment. Always keep
the casing closed to maintain the head's setting.
• The LS controller can operate normally at 0 to 45°C (32 to 113°F) [0 to
40°C (32 to 104°F) for LS-3036/3060] with no freezing and 35 to 85%RH
without condensation. Operation outside these ranges may result in
malfunction.
Do not connect or disconnect any cables while the power is ON. Otherwise,
the laser diode may deteriorate and/or may be damaged.
1. Connect the controller to the scanning head and the transmitter and
receiver using the supplied cables.
The LS-3101(W) can be used with LS-3032, 3033, 3036 and 3060.
CAUTION
Note
LS-3032, LS-3034, LS-3036
LS-3033, LS-3033 SO, LS-3060
CAUTION
08.10.1, 10:49 AM 4