KEYENCE LS-3100/3100W Series - Manual (Page 39)

33
CHAPTER 4 Functions and Controls
1. Use FNC to display the current segments for X and Y.
2. Use UP/DOWN to move the cursor up.
3. Each time you press SET, "DIA", "EDGE1", "EDGE2", "(m,n)", and "DIA"
will sequentially appear on the right of "X=". Display the desired segment.
* "m" and "n" in (m,n) represent two desired edge numbers.
4. When you have selected "(m,n)", enter the desired edge numbers, and
press ENT to register.
➪ See P.31.
Once you select "(m,n)" for X, "(m,n)" will be automatically selected for Y.
5. Use UP/DOWN to move the cursor down.
6. Repeat steps 3 and 4.
Procedure 1:
Measuring 2 Segments with 1
Scanning Head
Example of Operation
X D
Y =
=
I
I A
D A
X
E Y =
= I
D G
D A
E I
X (
Y =
= 2 , 3 )
( 1 , 2 )
You are to measure the outer diameter and eccentricity of the round bars
using one scanning head.
Step Key operation Display
1 Use FNC to display current
segments.
2 Use UP/DOWN to move
cursor up.
3 Use SET to display:
(1) "X= DIA"
(2) "X= (m,n)". Enter 2 for
"m" and 3 for "n", and press
ENT.
(To be continued)
X D
Y =
=
I
I A
D A
X D
Y =
=
I
I A
D A
X D
Y =
=
I
I A
D A
X (
Y =
= 2 , 3 )
( 1 , 2 )
Y
Edge 1
Transmitter Receiver
X
Edge 2
Edge 3
Edge 4
X (
Y =
= 2 , 3 )
( 1 , 2 )
08.10.1, 10:55 AM 33