Objects for use with the cb-ep100, Objects for use with the cb-ep100 -36 – KEYENCE CB-EP100 User Manual
Page 60
- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
3-4 Message Communication
3-36
3
Communi
cat
in
g wit
h the
L
J
-V700
0 Ser
ies
The following describes the objects for use with the CB-EP100.
Objects for use with the CB-EP100
Command
Response
CB
Object
Message
Router
Object
Connection
Manager
Object
Assembly
Object
Identity
Object
TCP/IP
Interface
Object
Ethernet
Link
Object
EtherNet/IP unit
Object Name
Class ID
Description
Reference
Page
CB Object
6BH
This object provides the statuses of the CB-EP100
and the Measuring instrument connected to the CB-
EP100 and writes and reads parameters. This object
is unique to the CB-EP100.
Identity Object
01H
This object provides identification information,
general information and a reset service, etc.
Message Router
Object
02H
This object provides connection points for message
communication.
Assembly Object
04H
This object provides access to the devices via cyclic
communication. This object can be used to send data
to the devices that do not support cyclic
communication.
Connection
Manager Object
06H
This object is used for connection-type
communication.
TCP/IP Interface
Object
F5H
This object provides the structure for setting the TCP/
IP network interface. You can set an IP address,
subnet mask and gateway, etc., in this object.
Ethernet Link Object
F6H
This object provides Ethernet status information.