KEYENCE CB-EP100 - Manual (Page 111)

3-87
3
Communi
cat
in
g wit
h the
L
J
-V700
0 Ser
ies
- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
3-5
Communication functions other than EtherNet/IP
„ Communication functions other than EtherNet/IP
In addition to EtherNet/IP communications, CB-EP100 allows you to use the the
following communication methods by connecting an Ethernet cable to the RJ-45
connector.
• Communication with the "LJ-Navigator2" software supplied with the LJ-V7000
series
• Sending and receiving PLC and PC commands using the LJ-V7000 series
protocol
Using multiple communication functions together may prevent them from
achieving their best performance.
Communication with the "LJ-Navigator2" software supplied with the LJ-
V7000 series
Connecting to a PC where the LJ-Navigator2 is installed allows communication
between the LJ-Navigator2 and the LJ-V7000 series controller via the CB-EP100.
All LJ-Navigator2 functions are then available.
For the operating instructions and details on the functions of LJ-Navigator2,
refer to the manual for LJ-Navigator2.
Sending and receiving PLC and PC commands using the LJ-V7000 series
protocol
The LJ-V7000 series protocol allows you to communicate with the LJ-V7000 series
controller via the CB-EP100.
A PC can use the communication library that the LJ-V7000 series provides.
However, only a command-based send and receive interface is available. A high-
speed communication interface is not available.
The communication library software and the reference manual can be
found on the "LJ-H2" CD-ROM supplied with the LJ-V7000 series. The port
number of the CB-EP100 is stored in the following attributes.
Class ID = 6BH
Instance ID = 00H
Attribute ID = 350H
The default value of this setting is 50000.
Set the IP address assigned to the CB-EP100 and the port number of the
CB-EP100 in the PC communication settings of LJ-Navigator2, and start
communication.
Point
Reference