BUCHI DuMaster D-480 - Manual (Page 247)

Operation Manual D-480 ©BÜCH Labortechnik AG
9 - Repairing the instrument 247
 Plug the protective earth conductor back into the rear wall.
 Attach the rear wall again.
Phase 4: Switch the instrument on again
Proceed as follows:
 Plug the power supply plug of the analyzer into the socket.
 Switch
 PC,
 monitor
 and printer on.
 Wait until the boot process is completed.
 Switch the main instrument switch on. The instrument performs a reference run of the VLS.
 Launch the operating software. See Starting the operating software (on page 130).
 Set the normal temperatures as the setpoint temperature of the furnaces. To do so, open the
"Instrument parameters" dialog in the operating software by selecting Options > Settings >
Parameters.
 Once the setpoint temperatures have been reached the instrument is ready to measure again.
What to do after a computer crash
After a computer crash
Because open documents are saved to a temporary file every 3 minutes, large-scale loss of data is
not usual. After a computer crash, restart the operating software and the software automatically loads
the most recent temporary file.