CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 77)

Port Information 9145E NID Software User’s Manual
Port Configuration
63
Figure 5-12 Port Filters Screen
5. UDLD Filter - When enabled, the 9145E will block Cisco Systems proprietary tagged and
untagged UDLD frames from passing through the unit. Use the Space Bar to cycle
between Enabled and Disabled.
6. Management VLAN Filter - When enabled, the 9145E will block traffic that is tagged with
the Management VLAN on the specified port. This will not affect management packets
that are addressed to the 9145E. Use the Space Bar to cycle between Disabled, User
Port Enabled, Net Port Enabled and Both Ports Enabled.
5.2.5 Port Based VLAN Control
The Port Based VLAN Control screen (Figure 5-13) is used to specify which VLANs, if any, are
allowed to pass through each port. The 9145E can be configured to support up to 100 VLANs.
From the Port Configuration screen, select Port Based VLAN Control (5) and press Enter. The
Port Based VLAN Control screen (Figure 5-13) opens. The default setting is All VLANs Allowed.
In order to specify which VLANs will be included or excluded, use the Add, Add Range, Delete,
and Delete Range controls at the bottom of the screen. Use Esc to return to the Port Based
VLAN Control screen.
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
Model 9145E-101-3-0 V43.16 F217 10:21:49
----------------------------------PORT FILTERS---------------------------------
1) PVST+ BPDU Filter Disabled
2) User Port Manager MAC Filter User Port Enabled
3) User Port Test Network Filter Disabled
4) 802.3ah OAM PDU Filter Disabled
5) UDLD Filter Enabled
6) Management VLAN Filter Both Ports Enabled
Select [1-6]:
------------------------------------Messages-----------------------------------