CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 149)

Service OAM 9145E NID Software User’s Manual
Maintenance End Points
135
11.6.3 Delete a Maintenance End Point
When you delete a Y.1731 Maintenance End Point, it is also deleted from the AIS client list.
1. On the Maintenance End Point List screen (Figure 11-18), type D and press . The
current MEP is highlighted.
2. Press to scroll through the list and highlight the entry you wish to delete.
3. Press to delete the highlighted MEP.
11.6.4 Modify a Maintenance End Point
1. On the Maintenance End Point List screen (Figure 11-18), type E and press . The
current MEP is highlighted.
2. Press to scroll through the list and highlight the entry to modify.
3. When the MEP you want to modify is highlighted, press . The Maintenance End
Point Attributes screen for that MEP opens (Figure 11-21 for 802.1ag or Figure 11-22 for
Y.1731).
4. To change the Admin Status, type 1 and press . Select Enabled or Disabled and
press .
5. To change CCM Transmit Status, type 2 and press . Select Enabled or Disabled
and press .
6. To change the Primary VLAN ID, type 3 and press . C-Tag indicates that ethernet
frames (CCMs, LBMs, LBRs, LTMs, LTRs) are tagged for customers. None means that
the frames are not tagged. Select a VLAN Tag Type and press .
7. To change the fault alarm detect time, type 4 and press . This is the time that
defects must be present before a fault alarm is issued. Type an entry between 2500 and
10000 milliseconds and press .
When a defect is detected, a fault alarm is raised. When the defect is no longer present, the fault
alarm is not cleared immediately. The system waits for the fault alarm clear time before clearing
the alarm.
8. To change the fault alarm clear time, type 5 and press . This is the time that
defects must be absent before a fault alarm is reset. Type an entry between 2500 and
10000 milliseconds and press .
9. To change the CCM/LTM Priority, type 6 and press . This is the priority parameter
(P-bits) for CCMs and LTMs transmitted by the MEP. Type a number from 0 to 7 and
press .