CANOGA PERKINS 9145E NID Software Version 3.0 User Manual
Page 150
9145E NID Software User’s Manual
Service OAM
Maintenance End Points
136
10. To change the lowest alarm priority, type 7 and press
equal or higher than the one specified will generate an alarm. Select from the list of
alarms (MacRemErrXcon, RemErrXcon, ErrXcon, Xcon, NoDefects, AllDefects) and
press
information:
• Fault notification state: The current state of the Fault Notification State generator.
• Defects: The current list of active defects.
• Next Linktrace trans. ID: The transaction ID that will be used in the next Linktrace
message.
• Next Loopback trans. ID: The transaction ID that will be used in the next Loopback
message.
11. If you are configuring a Y.1731 MEP, go to step 12. If you are configuring an 802.1ag
MEP, type A to accept the settings and press
tenance End Point List screen. If you are modifying a Y.1731 MEP (Figure 11-22):
12. To change the AIS Transmit interval, type 8 and press
press
13. To change the AIS priority bits, type 9 and press
press
14. Press
Figure 11-20. Maintenance End Point Attributes screen (802.1ag)
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2009
Model 9145E-104-0-0 V3.00 F214 05:15:27
-----------------------MAINTENANCE END POINT ATTRIBUTES-------------------------
MEP ID: 1 Direction: Down Level: 0
MA ID: 2 Port: Network MAC: 00:40:2A:01:EE:24
1) Admin status: Enabled
2) CCM Transmit status: Disabled
3) Primary VLAN ID: N/A
4) Fault alarm Detect time: 2500
5) Fault alarm clear time : 10000
6) CCM/LTM Priority: 7
7) Lowest alarm priority: MacRemErrXcon
Fault notification state: Reset
Defects: No defects.
Next Linktrace trans. ID: 1 Next Loopback trans. ID: 1
Select [1-7], (T) for Linktrace, (L) for Loopback:
------------------------------------Messages-----------------------------------