Banner SureCross DX80 Wireless Networks - Manual (Page 8)

This sends the I/O point configuration information to the DX80 devices. Once the Send ALL function has begun, click the Check Status
button at the bottom of the screen. A monitoring screen displays each device’s progress.
Other Commands
Check
Status Click the Check Status button to watch the sta-
tus of a Get ALL or Send ALL command. Send-
ing or retrieving information from the DX80 devi-
ces can take several minutes. Use the Check
Status button to verify the error status of the da-
ta transfer. When the list reads "Ready," the
command has finished.
Get
ALL Select the Get ALL checkbox and click the Up-
date button to pull set-up parameters from the
DX80 devices. These parameters will be loaded
into the Web Configurator screens but will not be
automatically saved into the XML file. Before
modifying any existing radio network devices, al-
ways perform a Get ALL to update the Web
Configurator with accurate set-up information.
Prev
and
Next If there are more than 16 devices or rules/maps,
use the Prev and Next buttons to display the
next screen of information.
Send
All After defining and setting up the devices and I/O
point parameters, select the Send ALL checkbox
and click the Update button to send this informa-
tion to the radio network devices.
Up-
date Clicking the Update button sends information to
the Ethernet Bridge or GatewayPro or retrieves in-
formation depending on which checkboxes are
selected: Change or Get/Send All. Updating infor-
mation does not save configuration information
permanently to the XML file.
Saving Changes to the XML File
To permanently save the changes to the XML file, go to the System > Setup > Config File page and click the Save button. Changes made
by clicking an Update button are temporary and only submitted to the Ethernet Bridge or GatewayPro, not the XML file.
Model List
Select from one of the following models to define your device.
None. No device is present
Discrete 4DI, 4DO. Discrete device with four discrete in and four discrete out.
Discrete 6DI, 6DO. Discrete device with six discrete in and six discrete out.
Discrete 8DI, 4DO. Discrete device with eight discrete in and four discrete out.
Discrete 4DI, 8DO. Discrete device with four discrete in and eight discrete out.
Mixed 2DI, 2DO, 2AI, 2AO. Device with two discrete in, two discrete out, two analog in, and two analog out. The term “mixed” refers to a
device with both discrete and analog I/O.
Mixed 4DI, 4DO, 2AI, 2AO. Device with four discrete in, four discrete out, two analog in, and two analog out.
Analog 4AI, 4AO. Device with four analog in and four analog out.
Flex 2DI, 2DO, 2AI. FlexPower™ Node with two discrete in, two discrete out, and two analog in.
Flex 2DI, 2DO, 4AI. FlexPower Node with two discrete in, two discrete out, and four analog in. This description also includes the Thermo-
couple and RTD nodes.
M-GAGE. FlexPower M-GAGE™ Node.
Other. Other model that isn't currently defined.
SureCross Web Configurator
8 www.bannerengineering.com - tel: 763-544-3164 rev. -