Banner SureCross DX80 Wireless Networks - Manual (Page 30)

Remote
Unit #
(Slave ID) The Remote Unit number is the slave ID of
the remote unit to be read. The value in this
register is then written to the local register lis-
ted. in the floating point register associated with the I/
O point.
Swap-
ped Check the Swapped box to swap the byte orien-
tation.
Update Clicking the Update button sends information to
the Ethernet Bridge or GatewayPro or retrieves
information depending on which checkboxes are
selected: Change or Get/Send All. Updating in-
formation does not save configuration informa-
tion permanently to the XML file.
Expanded RTU Read Map
The expanded view of the RTU Read Map contains the same parameters as on the original page in addition to a few more parameters.
For each remote register to be read, enter the register type, remote register format, remote register number, and device number (remote
unit number). Referring to the screen image, the following parameters may be set using this screen:
Parameter Parameter
1 Register type 8 Offset
2 Remote register format 9 Local register number
3 Remote register number 10 Name
4 Device number (remote unit number) 11 Periodic poll time
5 Doubles swapper 12 Default value
6 Bit mask 13 Read fail count
7 Scale
When the remote register is read, data may be manipulated before being written to the local register. If a bit mask is entered (in hexadeci-
mal), and the remote register type is signed or unsigned (16-bit data), the mask will be bit-wise logical AND-ed with the data, and the
SureCross Web Configurator
30 www.bannerengineering.com - tel: 763-544-3164 rev. -