Banner SureCross DX80 Wireless Networks - Manual (Page 36)

Local
Register The data in the local register is multiplied by
the scale factor, then written to the remote
register.
Name The name is optional and used only for dis-
play purposes. Names are defined on the De-
vices page, local name field.
Prev and
Next If there are more than 16 devices or rules/
maps, use the Prev and Next buttons to dis-
play the next screen of information.
Remote
Device The local names from the Devices tab are lis-
ted in this drop-down list.
Remote
Register
Format Select the format of the remote register from
integer, unsigned, double, float, or bit. An inte-
ger is a 16-bit (signed) number, an unsigned
format is a 16-bit unsigned number, a double
refers to a double precision (32-bit) value, a
floating value is a floating point number, and a
bit value is a single bit that can either be a 0
or a 1 (discrete value.)
Remote
Register
Number The Remote Register entry is the register
number being written to in the mapping.
Re-
mote
Type Select a Remote Type from the following drop-
down list: none, coil (output), discrete input, input
register, or holding register. Banner Engineering’s
SureCross™ slave devices use only input regis-
ters and holding registers. When using slave devi-
ces from other manufacturers, please refer to the
manufacturer’s documentation to determine what
I/O types are used.
• None
• Coil (output). 1xxxx - Other slave devices,
write only, 1 bit
• Discrete Input. 3xxxx - Other slave devices,
read only, 1 bit
• Input Register. 3xxxx - SureCross™ slave de-
vices, read only, 16 bit
• Holding Register. 4xxxx - SureCross slave de-
vices, read/write, 16 bit
Selecting None for remote type negates the rule,
though it remains in the list until deleted. To pre-
vent unused rules from displaying, reduce the
number of maps enabled on the expanded view.
Scale The raw data in the local register is multiplied by
the scale factor to produce the data appearing in
the floating point register associated with the I/O
point.
Up-
date Clicking the Update button sends information to
the Ethernet Bridge or GatewayPro or retrieves in-
formation depending on which checkboxes are se-
lected: Change or Get/Send All. Updating informa-
tion does not save configuration information per-
manently to the XML file.
Expanded Client Write Map
Like the RTU Read Map expanded view, the Client Write Map expanded view contains some of the same parameters as the Client Write
Map primary view, in addition to a few more parameters.
Refer to the RTU Read Map expanded view section for more information about these parameters ( GUID-5EBD5A53-1BF9-4F16-
B92D-60E91D2E058C.xml ).
Server Map
The Server Map page sets up the register map for a virtual Modbus/TCP server, allowing a custom view of remote registers.
SureCross Web Configurator
36 www.bannerengineering.com - tel: 763-544-3164 rev. -