Banner SureCross DX80 Wireless Networks - Manual

Configurable Gateway with discrete inputs and outputs for use with the M-GAGE™ Node
IP67 Base
2.4 GHz
IP20 Base
900 MHz
For additional information, upda-
ted documentation, and acces-
sories, refer to Banner Engi-
neering's website,
www.banner-
engineering.com/surecross .
The SureCross® wireless system is a radio frequency network with integrated I/O that can operate in
most environments and eliminate the need for wiring runs. Wireless networks are formed around a
Gateway, which acts as the wireless network master device, and one or more Nodes.
• Wireless industrial I/O device with six selectable discrete inputs and six sourcing discrete outputs
• Gateway’s discrete inputs are mapped to baseline up to six M-GAGE™ Nodes; MGAGE inputs
are mapped to the Gateway’s outputs
• 10 to 30V dc power input
• DIP switches for user configuration
• Modbus serial interface
• Site Survey analyzes the network’s signal strength and reliability and displays the results on the
Gateway's LCD
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple Access
(TDMA) control architecture ensure reliable data delivery within the unlicensed Industrial, Scientif-
ic, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, including fully
acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
Models Frequency Environmental Rating I/O
DX80G9M6S6P6Z 900 MHz ISM Band
IP67, NEMA 6
Inputs: Six selectable discrete
Outputs: Six sourcing discrete
DX80G2M6S6P6Z 2.4 GHz ISM Band
DX80G9M6S6P6ZC 900 MHz ISM Band
IP20, NEMA 1
DX80G2M6S6P6ZC 2.4 GHz ISM Band
Internal antenna models are also available, but are not UL Listed. For more information, contact your local Banner Engineering Corp.
representative.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious
injury or death. This device does not include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition.
The SureCross® DX80 Wireless Network
Gateway
Node
Node
FlexPower Node
and Battery Supply Module
The SureCross® DX80 wireless I/O network provides reliable moni-
toring without wiring or conduit installation. The SureCross wireless
network operates independently or in conjunction with a host system,
PLC, and/or PC software.
Each wireless network system consists of one Gateway and one or
more Nodes. Devices ship with factory-defined discrete, analog, or a
mix of discrete and analog inputs and outputs.
The SureCross® DX80 network is a deterministic system—the net-
work identifies when the radio signal is lost and drives relevant out-
SureCross DX80 Gateway for M-GAGEs
P/N 134303 Rev. H 5/24/2013
0 134303 3