Bird Technologies SA-6000XT-Manual - Manual (Page 95)

79
Replacing the Battery
1. Lay the Site Analyzer, display side down, on a clean surface.
2. Remove four screws and the battery cover.
Note: Check the direction of the notch in the battery cover. It is
important to replace the cover the same way it was removed.
3. Remove the foam battery pad to access the battery wire.
Figure 74 Replacing the Battery
.
4. Disconnect and remove the old battery pack from the compartment.
5. Install the new battery.
Note: Ensure the battery connector is firmly connected to the circuit
board connector.
6. Place the battery in the battery compartment.
Note: Ensure the battery is flat in the compartment, and will not
damage any wires when the cover is installed.
7. Replace the battery cover and the screws.
8. Connect the AC adapter to the unit.
9. Apply power to the unit and verify that it operates properly.
10. Charge the battery if required.