beautypg.com

Setting the graph display type – Bird Technologies SA-6000XT-Manual User Manual

Page 34

background image

18

Figure 14 Setting the Number of Measurement Data Points

Setting the Graph Display Type

When the Site Analyzer collects data during a sweep, the unit can specify that it mea-
sure 238 data points, 475 data points, or 949 data points. Selecting 475 data points
takes twice as much time to sweep as 238 points, and 949 points takes four times as

much time to sweep as 238 points.

The Site Analyzer display screen graph area can display only 238 points because of its
physical pixel limitations. However, if the trace contains 475 points or 949 points, all
points are represented on the display. There are three modes available to display the
data points for the trace: envelope, maximum, and minimum. For 238 data points,
there is no difference in the display for each of the three modes because each data
point occupies a separate pixel. For 475 data points and 949 data points, the envelope

mode displays all data points, the maximum mode displays only the highest (peak)
magnitude data point for each pixel, and the minimum mode displays only the lowest
(minimum) magnitude data point for each pixel.

Note: When saving (or downloading) a trace, all measured data points
(238, 475, 949) are saved (or downloaded). The display modes (enve-

lope, maximum, minimum) are for the Site Analyzer display only and are
not saved (or downloaded) with the trace.

1.

Enable the Measure Match Mode. See “Selecting the Measure Match

Mode” on page 13.

2.

Set the frequency. See “Setting the Measurement Frequency” on page 14.

3.

Calibrate the Site Analyzer. See “Calibration” on page 11.

4.

Press the Config key.

5.

Press the Scale softkey.

6.

Press the left or right scroll key to select Disp.

7.

Press the up scroll key to open the selection list.

8.

Press the up or down scroll key to select a display type (envelope, maxi-

mum, minimum).

9.

Press the Enter key to accept the selection and return to the configuration screen.

This manual is related to the following products: