Setting the scale & unit of measure, Setting fault location scale units, Figure 27 setting fault location scale units – Bird Technologies SA-6000XT-Manual User Manual
Page 49: Setting fault location scale limits manually
33
Setting the Scale & Unit of Measure
Set the display scale manually or by using Auto Scale. The display trace can be in
units of return loss [dB] or VSWR [ratio]. Activate Auto Scale from the configuration
screen or from the main Fault Location screen.
Setting Fault Location Scale Units
1.
Press the Config key.
2.
Press the Scale softkey.
3.
Use the left or right scroll keys to select Units.
4.
Use the up or down scroll keys to activate the units menu and to select the
units desired.
5.
Press the Enter key.
6.
Press the Esc key to exit the configure screen.
Figure 27 Setting Fault Location Scale Units
Setting Fault Location Scale Limits Manually
1.
Press the Config key.
2.
Press the Scale softkey.
3.
Use the left or right scroll keys to select Min.
4.
Use the keypad to enter the value or use –60 as a limit.
5.
Press the Enter key.
6.
Use the left or right scroll keys to select Max.
7.
Use the keypad to enter the value or use 0 as a limit.
8.
Press the Enter key.
9.
Press the Esc key to exit the configure screen.