Bird Technologies SA-6000XT-Manual - Manual (Page 84)

68
Using Quicktext
Ensure that the unit is in either Measure Match mode or Fault Location mode to
use Quicktext. Quicktext text elements are appended to the text on the edit
line.
1.
Press the Save/Recall softkey.
2. Press the Label softkey.
3. Use the Delete softkey to delete unwanted text from the edit line.
4. Use the up or down scroll keys to position the text cursor where a Quicktext
element is to be inserted.
Note: Quicktext elements overwrite existing text from the insert cur-
sor location to the right. Quicktext characters will overwrite only the
number of existing text characters that equals the number of charac-
ters in the Quicktext element.
Example - If the existing text on the edit line is “005
ANTENNA SITE THREE” and the user wants to insert the
Quicktext element TOWER starting at the “S” in the word
SITE, the user would position the insert cursor on the “S”
in SITE and then select and add TOWER from the Quick-
text list. The resulting text on the edit line would be “005
ANTENNA TOWERTHREE” (five characters were
replaced starting at the cursor position).
5. Press the right scroll key to select the Quicktext column.
6. Press the up or down scroll keys to select a Quicktext text element.
7. Press the Enter key to insert the text element into the text on the edit line.
8. Press the Esc key to exit the label screen.
Figure 67 Inserting Quicktext Elements