beautypg.com

Selecting a sweep frequency from a band list, Selecting the measurement units – Bird Technologies SA-6000XT-Manual User Manual

Page 31

background image

15

Selecting a Sweep Frequency from a Band List

1.

Press the Config key.

2.

Press the Freq softkey.

3.

Select Start, Stop, Center, or Span using the left or right scroll keys.

4.

Open the band list menu using the up or down scroll keys.

5.

Select the desired band using the up or down scroll keys.

6.

Press the Enter key to accept the selection.

7.

Press the Esc key to exit the configure screen.

Figure 11 Selecting a Sweep Frequency from a Band List

Selecting the Measurement Units

Select units before or after making a measurement. When making a match mea-
surement, select one of three units for the Y (vertical) scale,

VSWR (ratio)

Rtn Loss (dB)

Cbl Loss (dB)

1.

Enable the Measure Match Mode. See “Selecting the Measure Match
Mode” on page 13.

2.

Set the frequency. See “Setting the Measurement Frequency” on page 14.

3.

Calibrate the Site Analyzer. See “Calibration” on page 11.

4.

Press the Config key.

5.

Press the Scale softkey.

6.

Select units by pressing the left or right scroll keys.

7.

Open the units list menu by pressing the up or down scroll keys.

8.

Select the desired units by pressing the up or down scroll keys.

9.

Press the Enter key to accept the selection.

10. Press the Esc key to exit the configure screen.

This manual is related to the following products: