Bird Technologies SA-6000XT-Manual - Manual (Page 80)

64
Deleting a Saved Setup
Note: Only in Measure Match mode or Fault Location mode can a
setup be deleted.
1. Press the Save/Recall softkey.
2. Press the Setup softkey.
3. Press the up and down scroll keys to select a setup to delete.
4. Press the Delete softkey.
Note: The message “Are Your Sure?” appears beside the softkey.
Press the Delete softkey a second time to confirm the delete or press
the Esc key to cancel the delete.
5. Press the Esc key to exit the Save and Recall screen.
Figure 62 Deleting a Saved Setup
Label Text
Label Text Shortcuts
Typically when entering or editing label text, use the right and left scroll keys to
select columns of letters. Using shortcuts allows selection of a column of letters
by pressing a number on the key pad. When shortcuts are enabled, each column
is identified by a number at the bottom. Press the number key once to select
the column, and twice to enter a number.
1.
Press the Save/Recall softkey.
2. Press the Save softkey.
3. Press Config key to enter text label setup.
4. Press softkey to enable or disable shortcuts.
5. Press the Done softkey or Enter key to exit configure screen.
6. Press the Esc key two times to return to the test mode screen.